تعداد نشریات | 161 |
تعداد شمارهها | 6,572 |
تعداد مقالات | 71,006 |
تعداد مشاهده مقاله | 125,494,369 |
تعداد دریافت فایل اصل مقاله | 98,755,208 |
ظرفیت باربری پیهای واقع بر شیروانیهای مقعر در پلان به روش آنالیز حدی مرز بالا | ||
نشریه مهندسی عمران و نقشه برداری | ||
مقاله 8، دوره 44، شماره 2 - شماره پیاپی 212548، تیر 1389 اصل مقاله (488.13 K) | ||
نویسندگان | ||
اورنگ فرزانه1؛ فرجالله عسکری2؛ رضا یگانه خاکسار1 | ||
1دانشگاه تهران | ||
2پژوهشگاه بین المللی زلزله شناسی | ||
چکیده | ||
ظرفیت باربری پیهای واقع بر شیروانیهای مقعر در پلان، موضوعی است سهبعدی که فرض دوبعدی آن نمیتواند جوابهای دقیقی را ارائه کند. در این مقاله با استفاده از روش تحلیل حدی مرز بالا، الگوریتمی برای محاسبه ظرفیت باربری پیهای واقع بر اینگونه شیروانیها بهروش سهبعدی ارائه شده است. در این الگوریتم، مکانیسم گسیختگی به صورت مجموعهای از بلوکهای پنج یا ششوجهی در نظر گرفته میشود و طی یک فرآیند بهینهسازی، کمترین جواب ممکن بهعنوان بار حدی شیروانی به دست میآید. تحلیلهای انجامشده با الگوریتم مزبور نشان میدهد که ظرفیت باربری پیهای واقع بر شیروانیهای مقعر در شرایط یکسان از ظرفیت باربری پیهای واقع بر شیروانیهای خطی در پلان بیشتر است و هر چه نسبت شعاع شیروانی به ارتفاع آن کوچکتر شود، میزان ظرفیت باربری پیهای واقع بر آن افزایش خواهد یافت. نتایج حاصل از مطالعه حاضر به شکل نمودارهای کاربردی برای به دست آوردن بار حدی این گونه شیروانیها برای استفاده مهندسان ارائه شده است. | ||
کلیدواژهها | ||
بارحدی؛ تحلیل سهبعدی؛ روش آنالیز حدی مرز بالا؛ شیروانی مقعر در پلان؛ ظرفیت باربری | ||
عنوان مقاله [English] | ||
Bearing Capacity of Foundations Located on Concave Slopes in Plan View Using Upper Bound Theorem | ||
نویسندگان [English] | ||
Orang Farzaneh1؛ Farajollah Askari2؛ Reza Yeganeh Khaksar1 | ||
چکیده [English] | ||
Bearing Capacity of concave slopes is such a three-dimensional problem that two-dimensional assumptions do not result in satisfactory and acceptable results. Presented in this article is an algorithm to calculate the bearing capacity of foundations located on such slopes based on the upper bound theorem of the limit analysis approach. Limit analysis method is based on the extensions of maximum work principle derived by Hill, and was given in the form of theorems by Drucker, Prager and Greenberg. Using this approach, the true solution from a lower bound to an upper bound would be bracketed. Applicability of this theorem requires that the soil’s behavior be perfectly plastic and the deformation be governed by the normality rule. Considering the theorem of kinematic approach (upper-bound), the rate of work done by traction and body forces would be less than or equal to the energy dissipation rate in any assumed kinematically admissible failure mechanism. In this algorithm, initially the collapse mechanism is assumed as a set of five or six-face rigid blocks slipping on each other with enrgy dissipation taking place along planar velocity discontinuities. and then, during an optimizing process the minimum result would be considered as the ultimate load of the slope. This approach can be considered as an extension of the procedure proposed by Farzaneh and Askari in 1999. The numerical results indicate that the bearing capacity of a shallow foundation on concave slope is more than that of the same foundation on linear slope and also fewer is the ratio of slope radius to its height, more would be the bearing capacity of the foundation located on it. In addition, unloaded slopes are more stable when they are concave comparing with linear slopes. In bearing capacity, the curvature effect in concave slopes is more considerable for frictional soils than cohesive ones. The results are presented in the form of applicable charts to evaluate the bearing capacity of a foundation located on a concave slope. | ||
کلیدواژهها [English] | ||
Bearing Capacity, Concave slope in Plan View, Limit Analysis Approach, Three-Dimensional Analysis, Upper Bound Theorem | ||
آمار تعداد مشاهده مقاله: 1,412 تعداد دریافت فایل اصل مقاله: 1,374 |