پیوندهای مفید
اخبار و اعلانات
آمار
| تعداد نشریات | 158 |
| تعداد شمارهها | 6,230 |
| تعداد مقالات | 67,764 |
| تعداد مشاهده مقاله | 115,175,453 |
| تعداد دریافت فایل اصل مقاله | 89,924,047 |
Numerical Study of Progressive Collapse in Intermediate Moment Resisting Reinforced Concrete Frame Due to Column Removal | ||
| Civil Engineering Infrastructures Journal | ||
| مقاله 6، دوره 47، شماره 1، شهریور 2014، صفحه 71-88 اصل مقاله (1.23 M) | ||
| نوع مقاله: Research Papers | ||
| شناسه دیجیتال (DOI): 10.7508/ceij.2014.01.006 | ||
| نویسندگان | ||
| Seyed Mehdi Zahrai* 1؛ Alireza Ezoddin2 | ||
| 1Associate Professor, Center of Excellence for Engineering and Management of Civil Infrastructures, School of Civil Engineering, College of Engineering, University of Tehran, P.O.Box: 11155-4563, Tehran, Iran. | ||
| 2Ph.D. Student, Faculty of Civil Engineering, University of Semnan, Semnan, Iran. | ||
| چکیده | ||
| Progressive collapse is a chain reaction of failures propagating throughout a portion of the structure disproportionate to the original local failure occurring when a sudden loss of a critical load‐bearing element initiates a structural element failure, eventually resulting in partial or full collapse of the structure. Both General Services Administration (GSA) and United States Department of Defense (DoD) guidelines incorporate a threat-independent approach to progressive collapse analysis. Therefore, there is an international trend for updating structural design requirements to explicitly design structures to resist progressive collapse. This paper presents simple analytical approach for evaluating progressive collapse potential of typical concrete buildings, comparing four methods for progressive collapse analysis by studying 5 and 10-story intermediate moment-resistant reinforced concrete frame buildings, employing increasingly more complex analytical procedures: linear-elastic static, nonlinear static, linear-elastic dynamic, and nonlinear dynamic methodologies. Each procedure is thoroughly investigated and its common shortcomings are identified. The evaluation uses current GSA progressive collapse guidelines and can be used in routine design by practicing engineers. These analyses for three column-removal conditions are performed to evaluate the behavior of RC buildings under progressive collapse. Based on obtained findings, dynamic analysis procedures -easy to perform for progressive collapse determination- yielded more accurate results. | ||
| کلیدواژهها | ||
| Intermediate Moment Resisting Frame؛ Linear Dynamic Analysis؛ Linear Static Analysis؛ Nonlinear Dynamic Analysis؛ Nonlinear Static Analysis؛ Progressive Collapse؛ Reinforced concrete | ||
| مراجع | ||
|
American Concrete Institute (ACI), (2008). Building code requirements for structural concrete and commentary (ACI 318m-08), Detroit, Michigan.
ASCE. (2005). SEI/ASCE 7-05 minimum design loads for buildings and other structures. Washington DC, American Society of Civil Engineers.
BHRC. (2007). Iranian Code of Practice for Seismic Resistant Design of Buildings, Standard No. 2800 (3rd Edition), Building and Housing Research Center. BHRC Publication No. S – 465, 1st print.
Buscemi, N. and Marjanishvili, S.M. (2005). "SDOF model for progressive collapse analysis", Proceedings of SEI Structures Congress, ASCE, Reston, Va.
CSI, SAP2000 V-14.0.0, (2009). Integrated finite element analysis and design of structures basic analysis reference manual, Computers and Structures Inc., Berkeley, CA, USA.
Department of Defense (DoD). (2009). Design of buildings to resist progressive collapse, (UFC 4-023-03).Washington D.C.
FEMA 274. (1997). NEHRP Commentary on the guidelines for the seismic rehabilitation of buildings, Washington D.C., Federal Emergency Management Agency.
FEMA-356, (2000). Prestandard and Commentary for the Seismic Rehabilitation of Buildings, Prepared by American Society of Civil Engineers, Reston, Virginia, prepared for Federal Emergency Management Agency, Washington D.C., Nov.
Grierson, D., Safi, M., Xu, L. and Liu, Y. (2005)."Simplified methods for progressive collapse analysis of buildings", Proceedings of Metropolis and Beyond Structures Congress, ASCE, Reston, VA.
Hansen, E., Wong, F., Lawver, D., Oneto, R., Tennant, D. and Ettouney, M. (2005)."Development of an analytical database to support a fast running progressive collapse assessment tool", Proceedings of Metropolis and Beyond-Structures Congress, ASCE, Reston, VA.
Iranian code of practice for seismic resistant design of buildings. (2007). Standard 2800, 3rd Edition, BHRC Publication No. S – 465, 1st print.
Kaewkulchai, G. and Williamson, E. (2003). “Dynamic behavior of planar frames during progressive collapse”. Proceedings of the 16th ASCE Engineering Mechanics Conference, University of Washington, Seattle.
Kim, H.S., Kim, J. and An, D.W. (2009)."Development of integrated system for progressive collapse analysis of building structures considering dynamic effects", Advances in Engineering Software, 40, 1–8.
Kim, J. and Kim, T. (2009). "Assessment of progressive collapse-resisting capacity of steel moment frames", Journal of Constructional Steel Research, 65(1), 169 - 179.
Marjanishvili, S. and Agnew, E. (2006). "Comparison of various procedures for progressive collapse analysis", Journal of Performance of Constructed Facilities, ASCE, 20(4), 365–374.
Menchel, K., Thierry, J., Rammer, M.Y. and Bouillard, P. (2009)."Comparison and study of different progressive collapse simulation techniques for RC structures". Journal of Structural Engineering, ASCE, 135(6), 685-697.
Mohamed, O.A. (2009)."Assessment of progressive collapse potential in corner floor panels of reinforced concrete buildings", Engineering Structures, 31(3), 749-757.
National Institute of Standard and Technology (NIST 2007). Best practices for reducing the potential for progressive collapse in buildings, (Draft). U.S. Department of Commerce.
Powell, G. (2005). “Progressive collapse: Case study using nonlinear analysis”, Proceedings of the 2005 Structures Congress and the 2005 Forensic Engineering Symposium, New York, 2185–2198.
Pretlove, A.J., Ramsden, M. and Atkins, A.G. (1991).
"Dynamic effects in progressive failure of structures". International Journal of Impact Engineering, 11(4), 539-546.
The US General Services Administration. (GSA), (2003). Progressive collapse analysis and design guidelines for new federal office buildings and major modernization projects, US General Service Administration, Washington D.C.
Unified Facilities Criteria (UFC)-DoD, (2005). Design of Buildings to Resist Progressive Collapse, Department of Defense, Washington D.C. | ||
|
آمار تعداد مشاهده مقاله: 3,947 تعداد دریافت فایل اصل مقاله: 3,569 |
||