سامانه پشتیبانی خدمات اطلاعات

  اخبار و اعلانات

 آمار

تعداد نشریات161
تعداد شماره‌ها6,468
تعداد مقالات69,896
تعداد مشاهده مقاله122,418,207
تعداد دریافت فایل اصل مقاله95,662,967
Fatemi, Seyed Mahmood, Kazemi Asl, Ali Akbar, Abedi, Amir. (1398). The effect of twinning on texture evolution during ECAP processing of an AM30 magnesium alloy. , 52(2), 142-148. doi: 10.22059/jufgnsm.2019.02.02
Seyed Mahmood Fatemi; Ali Akbar Kazemi Asl; Amir Abedi. "The effect of twinning on texture evolution during ECAP processing of an AM30 magnesium alloy". , 52, 2, 1398, 142-148. doi: 10.22059/jufgnsm.2019.02.02
Fatemi, Seyed Mahmood, Kazemi Asl, Ali Akbar, Abedi, Amir. (1398). 'The effect of twinning on texture evolution during ECAP processing of an AM30 magnesium alloy', , 52(2), pp. 142-148. doi: 10.22059/jufgnsm.2019.02.02
Fatemi, Seyed Mahmood, Kazemi Asl, Ali Akbar, Abedi, Amir. The effect of twinning on texture evolution during ECAP processing of an AM30 magnesium alloy. , 1398; 52(2): 142-148. doi: 10.22059/jufgnsm.2019.02.02

The effect of twinning on texture evolution during ECAP processing of an AM30 magnesium alloy

Journal of Ultrafine Grained and Nanostructured Materials
مقاله 2، دوره 52، شماره 2، اسفند 2019، صفحه 142-148    اصل مقاله (2.83 M)
نوع مقاله: Research Paper
شناسه دیجیتال (DOI): 10.22059/jufgnsm.2019.02.02
نویسندگان
Seyed Mahmood Fatemi* ؛ Ali Akbar Kazemi Asl؛ Amir Abedi
Department of Metallurgy and Materials Engineering, Shahid Rajaee Teacher Training University, Lavizan, Tehran, Iran.
چکیده
An AM30 magnesium alloy was processed through ECAP method at 200 °C. Optical and transmission electron microscopy as well as electron back scattered diffraction (EBSD) technique were employed to characterize the deformed microstructure. A partially recrystallized microstructure including ultrafine/nano structures was obtained. The area fraction of 49% was measured for the recrystallized regions, where grains of 95 nm to 1 micron were detected.  X-ray diffraction pole figure measurements were conducted to assess the final texture. The processed material exhibited moderate randomized texture including three basal pole peaks denoting the effect of dynamic recrystallization on deformation texture. TEM analysis confirmed the contribution of nano twinning during deformation of AM30 alloy. EBSD characterization implied that extension twin may contribute to the nucleation of new grains and thereby to be related to texture evolution.  The apparent crossing pattern of intersected extension twins provided fine domains with high angle grain boundaries, which act as DRX nuclei. The formation of intersection boundaries also plays a critical role in pileup of dislocations and provide a local high stored-energy for dynamic recrystallization nucleation site. The aforementioned recrystallization mechanisms generally adopt orientations which are different from those produced by conventional recrystallization mechanisms, and thus it offers a route to manipulate the texture.
کلیدواژه‌ها
recrystallization؛ texture؛ twinning؛ magnesium
مراجع

1. Al-Samman T, Gottstein G. Dynamic recrystallization during high temperature deformation of magnesium. Materials Science and Engineering: A. 2008;490(1-2):411-20.

2. Mackenzie L, Pekguleryuz M. The recrystallization and texture of magnesium–zinc–cerium alloys. Scripta Materialia. 2008;59(6):665-8.

3. Xue Y, Chen S, Liu H, Zhang Z, Ren L, Bai B. Effect of Cyclic Expansion-Extrusion Process on Microstructure, Deformation and Dynamic Recrystallization Mechanisms, and Texture Evolution of AZ80 Magnesium Alloy. Advances in Materials Science and Engineering. 2019;2019:1-10.

4. Zeng ZR, Zhu YM, Xu SW, Bian MZ, Davies CHJ, Birbilis N, et al. Texture evolution during static recrystallization of cold-rolled magnesium alloys. Acta Materialia. 2016;105:479-94.

5. Üçel İB, Kapan E, Türkoğlu O, Aydıner CC. In situ investigation of strain heterogeneity and microstructural shear bands in rolled Magnesium AZ31. International Journal of Plasticity. 2019;118:233-51.

6. Pekguleryuz MO. Current developments in wrought magnesium alloys. Advances in Wrought Magnesium Alloys: Elsevier; 2012. p. 3-62.

7. Kwak TY, Kim WJ. Effect of refinement of grains and icosahedral phase on hot compressive deformation and processing maps of Mg-Zn-Y magnesium alloys with different volume fractions of icosahedral phase. Journal of Materials Science & Technology. 2019;35(1):181-91.

8. Zhao F, Ding X, Cui R, Fan X, Li Y, Shuang Y. Research on microstructure and texture of as-extruded AZ31 magnesium alloy during thermal compression. Journal of Materials Research. 2019;34(12):2114-25.

9. Wang Z, Guan Y, Wang T, Zhang Q, Wei X, Fang X, et al. Microstructure and mechanical properties of AZ31 magnesium alloy sheets processed by constrained groove pressing. Materials Science and Engineering: A. 2019;745:450-9.

10. Tan JC, Tan MJ. Dynamic continuous recrystallization characteristics in two stage deformation of Mg–3Al–1Zn alloy sheet. Materials Science and Engineering: A. 2003;339(1-2):124-32.

11. Mokdad F, Chen DL, Li DY. Twin-twin interactions and contraction twin formation in an extruded magnesium alloy subjected to an alteration of compressive direction. Journal of Alloys and Compounds. 2018;737:549-60.

12. Song L, Wu B, Zhang L, Du X, Wang Y, Esling C. Twinning characterization of fiber-textured AZ31B magnesium alloy during tensile deformation. Materials Science and Engineering: A. 2018;710:57-65.

13. Zhu B, Liu X, Xie C, Wu Y, Zhang J. {10–12} extension twin variant selection under a high train rate in AZ31 magnesium alloy during the plane strain compression. Vacuum. 2019;160:279-85.

14. Guan D, Rainforth WM, Ma L, Wynne B, Gao J. Twin recrystallization mechanisms and exceptional contribution to texture evolution during annealing in a magnesium alloy. Acta Materialia. 2017;126:132-44.

15. Li X, Yang P, Wang LN, Meng L, Cui F. Orientational analysis of static recrystallization at compression twins in a magnesium alloy AZ31. Materials Science and Engineering: A. 2009;517(1-2):160-9.

16. Estrin Y, Yi SB, Brokmeier HG, Zúberová Z, Yoon SC, Kim HS, et al. Microstructure, texture and mechanical properties of the magnesium alloy AZ31 processed by ECAP. International Journal of Materials Research. 2008;99(1):50-5.

17. Martynenko N, Lukyanova E, Serebryany V, Prosvirnin D, Terentiev V, Raab G, et al. Effect of equal channel angular pressing on structure, texture, mechanical and in-service properties of a biodegradable magnesium alloy. Materials Letters. 2019;238:218-21.

18. Mostaed E, Hashempour M, Fabrizi A, Dellasega D, Bestetti M, Bonollo F, et al. Microstructure, texture evolution, mechanical properties and corrosion behavior of ECAP processed ZK60 magnesium alloy for biodegradable applications. Journal of the Mechanical Behavior of Biomedical Materials. 2014;37:307-22.

19. Sadeghi A, Pekguleryuz M. Recrystallization and texture evolution of Mg–3%Al–1%Zn–(0.4–0.8)%Sr alloys during extrusion. Materials Science and Engineering: A. 2011;528(3):1678-85.

20. Fatemi-Varzaneh SM, Zarei-Hanzaki A, Cabrera JM, Calvillo PR. EBSD characterization of repetitive grain refinement in AZ31 magnesium alloy. Materials Chemistry and Physics. 2015;149-150:339-43.

21. Fatemi SM, Zarei-Hanzaki A. Microband/twin recrystallization during back extrusion of AZ31 magnesium. Materials Science and Engineering: A. 2017;708:230-6.

22. Smith AE. Surface, interface and stacking fault energies of magnesium from first principles calculations. Surface Science. 2007;601(24):5762-5.

23. Jin L, Lin D, Mao D, Zeng X, Chen B, Ding W. Microstructure evolution of AZ31 Mg alloy during equal channel angular extrusion. Materials Science and Engineering: A. 2006;423(1-2):247-52.

24. Jiang MG, Xu C, Yan H, Fan GH, Nakata T, Lao CS, et al. Unveiling the formation of basal texture variations based on twinning and dynamic recrystallization in AZ31 magnesium alloy during extrusion. Acta Materialia. 2018;157:53-71.

25. Chen H, Liu T, Xiang S, Liang Y. Abnormal migration of twin boundaries in rolled AZ31 alloy containing intersecting {101¯2} extension twins. Journal of Alloys and Compounds. 2017;690:376-80.

26. Sun Q, Zhang X, Ren Y, Tan L, Tu J. Observations on the intersection between 101̅2 twin variants sharing the same zone axis in deformed magnesium alloy. Materials Characterization. 2015;109:160-3.

آمار
تعداد مشاهده مقاله: 1,035
تعداد دریافت فایل اصل مقاله: 768


سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب