پیوندهای مفید
اخبار و اعلانات
آمار
| تعداد نشریات | 158 |
| تعداد شماره‌ها | 6,225 |
| تعداد مقالات | 67,685 |
| تعداد مشاهده مقاله | 114,967,072 |
| تعداد دریافت فایل اصل مقاله | 89,640,669 |
Experimental Investigation of Drag Reduction in Turbulent Flow Using Biological and Synthetic Macromolecules: A Comparative Study | ||
| Journal of Chemical and Petroleum Engineering | ||
| دوره 55، شماره 1، شهریور 2021، صفحه 117-137 اصل مقاله (1.43 M) | ||
| نوع مقاله: Research Paper | ||
| شناسه دیجیتال (DOI): 10.22059/jchpe.2021.307767.1323 | ||
| نویسندگان | ||
| Behrouz Raei* ؛ Seyed Mohsen Peyghambarzadeh | ||
| Department of Chemical Engineering, Mahshahr Branch, Islamic Azad University, Mahshahr, Iran | ||
| چکیده | ||
| It was shown that the concept of drag-reducing in the pipe flow with the aid of macromolecules is of great importance in practical engineering applications. In this study, the drag-reducing the performance of three biological macromolecules including guar gum (GG), xanthan gum (XG), and carboxymethyl cellulose (CMC) was compared with three synthetic macromolecules including polyethylene oxide (PEO), polyacrylamide (PAM), and polyacrylic acid (PAA). Results showed that all the macromolecules enhanced the DR% except for GG. DR% for almost all of the macromolecules deteriorated with increasing fluid flow rate. On the other hand, DR% enhanced with increasing the pipe diameter for the synthetic polymers but this effect is not obvious for biological polymeric solutions. Maximum DR was 44%, which occur at 1000 ppm concentration of XG at 30 °C and flow rate of 6 l/min and diameter ½ inch. Finally, a new correlation was developed for the prediction of friction coefficient based on the Prandtl-Karman relation with the newly adjusted slope which is a linear function of polymer concentration. This correlation was in excellent agreement with the experimental data. | ||
| کلیدواژه‌ها | ||
| Friction Coefficient؛ Pipe؛ Polymer؛ Practical؛ Solution | ||
|
سایر فایل های مرتبط با مقاله
|
||
| مراجع | ||
|
Stenzel V, Wilke Y, Hage W. Drag-reducing paints for the reduction of fuel consumption in aviation and shipping. Progress in Organic Coatings. 2011 Apr 1;70(4):224-9. [2] Toms BA. Some observations on the flow of linear polymer solutions through straight tubes at large Reynolds numbers. Proc. of In. Cong. On Rheology, 1948. 1948;135. [3] Raei B, Shahraki F, Peyghambarzadeh SM. Experimental study of the effect of drag reducing agent on heat transfer and pressure drop characteristics. Experimental Heat Transfer. 2018 Jan 2;31(1):68-84. [4] Karami HR, Mowla D. Investigation of the effects of various parameters on pressure drop reduction in crude oil pipelines by drag reducing agents. Journal of Non-Newtonian Fluid Mechanics. 2012 Jun 1;177:37-45. [5] Sandoval GA, Soares EJ. Effect of combined polymers on the loss of efficiency caused by mechanical degradation in drag reducing flows through straight tubes. Rheologica Acta. 2016 Jul;55(7):559-69. [6] Steele A, Bayer IS, Loth E. Pipe flow drag reduction effects from carbon nanotube additives. Carbon. 2014 Oct 1;77:1183-6. [7] Karami HR, Rahimi M, Ovaysi S. Degradation of drag reducing polymers in aqueous solutions, Korean Journal of Chemical Engineering, 2018;35(1):34-43. [8] Joseph DD, Narain A, Riccius O, Arney M. Shear-wave speeds and elastic moduli for different liquids-Theory and experiments. Journal of Fluid Mechanics, 1986;171:289-338. [9] De Gennes PG. Towards a scaling theory of drag reduction. Physica A: Statistical Mechanics and its Applications. 1986 Dec 1;140(1-2):9-25. [10] Lumley JL. Drag reduction by additives. Annual review of fluid mechanics. 1969 Jan;1(1):367-84. [11] Pereira AS, Andrade RM, Soares EJ. Drag reduction induced by flexible and rigid molecules in a turbulent flow into a rotating cylindrical double gap device: Comparison between Poly (ethylene oxide), Polyacrylamide, and Xanthan Gum. Journal of Non-Newtonian Fluid Mechanics. 2013 Dec 1;202:72-87. [12] Vanapalli SA, Islam MT, Solomon MJ. Scission-induced bounds on maximum polymer drag reduction in turbulent flow. Physics of Fluids. 2005 Sep 26;17(9):095108. [13] Virk PS. Drag reduction fundamentals. AIChE Journal. 1975 Jul;21(4):625-56. [14] Choi HJ, Jhon MS. Polymer-induced turbulent drag reduction. Industrial & engineering chemistry research. 1996 Sep 5;35(9):2993-8. [15] Am Kim C, Sung JH, Choi HJ, Kim CB, Chun W, Jhon MS. Drag reduction and mechanical degradation of poly (ethylene oxide) in seawater. Journal of chemical engineering of Japan. 1999;32(6):803-11. 136 Raei and Peyghambarzadeh [16] Choi HJ, Kim CA, Sung JH, Kim CB, Chun W, Jhon MS. Universal drag reduction characteristics of saline water-soluble poly (ethylene oxide) in a rotating disk apparatus. Colloid and Polymer Science. 2000 Jul;278(7):701-5. [17] Kim NJ, Kim S, Lim SH, Chen K, Chun W. Measurement of drag reduction in polymer added turbulent flow. International Communications in Heat and Mass Transfer. 2009 Dec 1;36(10):1014-9. [18] Sung JH, Kim CA, Choi HJ, Hur BK, Kim JG, Jhon MS. Turbulent drag reduction efficiency and mechanical degradation of poly (acrylamide). Journal of Macromolecular Science, Part B. 2004 Jan 1;43(2):507-18. [19] Sandoval GA, Trevelin R, Soares EJ, Silveira L, Thomaz F, Pereira AS. Polymer degradation in turbulent drag reducing flows in pipes. Revista de Engenharia Térmica. 2015 Dec 31;14(2):03-6. [20] Zhang X, Liu L, Cheng L, Guo Q, Zhang N. Experimental study on heat transfer and pressure drop characteristics of air–water two-phase flow with the effect of polyacrylamide additive in a horizontal circular tube. International Journal of Heat and Mass Transfer. 2013 Mar 1;58(1-2):427-40. [21] Zhang X, Liu L, Cheng L, Guo Q, Zhang N. Experimental study on heat transfer and pressure drop characteristics of air–water two-phase flow with the effect of polyacrylamide additive in a horizontal circular tube. International Journal of Heat and Mass Transfer. 2013 Mar 1;58(1-2):427-40. [22] Varnaseri M, Peyghambarzadeh SM, Amiri M. Experimental study on optimum concentration of polyacrylamide for drag reduction and heat transfer performance in a compact heat exchanger. Heat and Mass Transfer. 2019 May;55(5):1503-11. [23] Kim JT, Am Kim C, Zhang K, Jang CH, Choi HJ. Effect of polymer–surfactant interaction on its turbulent drag reduction. Colloids and Surfaces A: Physicochemical and Engineering Aspects. 2011 Nov 5;391(1-3):125-9. [24] Kim OK, Choi LS, Long T, McGrath K, Armistead JP, Yoon TH. Unusual complexation behavior of poly (acrylic acid) induced by shear. Macromolecules. 1993 Mar;26(2):379-84. [25] Zhang K, Choi HJ, Jang CH. Turbulent drag reduction characteristics of poly (acrylamide-co-acrylic acid) in a rotating disk apparatus. Colloid and Polymer Science. 2011 Nov;289(17):1821-7. [26] Zhang K, Lim GH, Choi HJ. Mechanical degradation of water-soluble acrylamide copolymer under a turbulent flow: Effect of molecular weight and temperature. Journal of Industrial and Engineering Chemistry. 2016 Jan 25;33:156-61. [27] Kim CA, Lim ST, Choi HJ, Sohn JI, Jhon MS. Characterization of drag reducing guar gum in a rotating disk flow. Journal of applied polymer science. 2002 Mar 28;83(13):2938-44. [28] Deshmukh SR, Chaturvedi PN, Singh RP. The turbulent drag reduction by graft copolymers of guargum and polyacrylamide. Journal of Applied Polymer Science. 1985 Oct;30(10):4013-8. [29] Hong CH, Zhang K, Choi HJ, Yoon SM. Mechanical degradation of polysaccharide guar gum under turbulent flow. Journal of Industrial and Engineering Chemistry. 2010 Mar 25;16(2):178-80. [30] Eshghinejadfard A, Sharma K, Thévenin D. Effect of polymer and fiber additives on pressure drop in a rectangular channel. Journal of Hydrodynamics. 2017 Oct;29(5):871-8. [31] Sohn JI, Kim CA, Choi HJ, Jhon MS. Drag-reduction effectiveness of xanthan gum in a rotating disk apparatus. Carbohydrate Polymers. 2001 May 1;45(1):61-8. [32] Hong CH, Choi HJ, Zhang K, Renou F, Grisel M. Effect of salt on turbulent drag reduction of xanthan gum. Carbohydrate polymers. 2015 May 5;121:342-7. [33] Andrade RM, Pereira AS, Soares EJ. Drag reduction in synthetic seawater by flexible and rigid polymer addition into a rotating cylindrical double gap device. Journal of Fluids Engineering. 2016 Feb 1;138(2). [34] Habibpour M, Koteeswaran S, Clark PE. Drag reduction behavior of hydrolyzed polyacrylamide/polysaccharide mixed polymer solutions—effect of solution salinity and polymer concentration. Rheologica Acta. 2017 Aug;56(7):683-94. Journal of Chemical and Petroleum Engineering 2020, 55(1): 117-137 137 [35] Deshmukh SR, Sudhakar K, Singh RP. Drag‐reduction efficiency, shear stability, and biodegradation resistance of carboxymethyl cellulose‐based and starch‐based graft copolymers. Journal of applied polymer science. 1991 Sep 20;43(6):1091-101. [36] Peyghambarzadeh SM, Hashemabadi SH, Saffarian H, Shekari F. Experimental study of the effect of drag reducing agent on pressure drop and thermal efficiency of an air cooler. Heat and Mass Transfer. 2016 Jan 1;52(1):63-72. [37] Biswal DR, Singh RP. Characterisation of carboxymethyl cellulose and polyacrylamide graft copolymer. Carbohydrate polymers. 2004 Sep 22;57(4):379-87. [38] Moffat RJ. Describing the uncertainties in experimental results. Experimental thermal and fluid science. 1988 Jan 1;1(1):3-17. [39] Wyatt NB, Gunther CM, Liberatore MW. Drag reduction effectiveness of dilute and entangled xanthan in turbulent pipe flow. Journal of Non-Newtonian Fluid Mechanics. 2011 Jan 1;166(1-2):25-31. [40] White FM. Fluid Mechanics fourth ed. [41] Raei B, Peyghambarzadeh SM, Asl RS. Experimental investigation on heat transfer and flow resistance of drag-reducing alumina nanofluid in a fin-and-tube heat exchanger. Applied Thermal Engineering. 2018 Nov 5;144:926-36. [42] Mowla D, Naderi A. Experimental study of drag reduction by a polymeric additive in slug two-phase flow of crude oil and air in horizontal pipes. Chemical Engineering Science. 2006 Mar 1;61(5):1549-54. [43] Virk PS, Sherman DC, Wagger DL. Additive equivalence during turbulent drag reduction. American Institute of Chemical Engineers. AIChE Journal. 1997 Dec 1;43(12):3257. [44] White CM, Mungal MG. Mechanics and prediction of turbulent drag reduction with polymer additives. Annu. Rev. Fluid Mech.. 2008 Jan 21;40:235-56. [45] Yang JC, Li FC, He YR, Huang YM, Jiang BC. Experimental study on the characteristics of heat transfer and flow resistance in turbulent pipe flows of viscoelastic-fluid-based Cu nanofluid. International Journal of Heat and Mass Transfer. 2013 Jul 1;62:303-13. [46] Interthal W, Wilski H. Drag reduction experiments with very large pipes. Colloid and Polymer Science. 1985 Mar;263(3):217-29. [47] Habibpour M, Clark PE. Drag reduction behavior of hydrolyzed polyacrylamide/xanthan gum mixed polymer solutions. Petroleum Science. 2017 May;14(2):412-23. [48] Elbing BR, Winkel ES, Solomon MJ, Ceccio SL. Degradation of homogeneous polymer solutions in high shear turbulent pipe flow. Experiments in fluids. 2009 Dec;47(6):1033-44. [49] Virk PS, Baher H. The effect of polymer concentration on drag reduction. Chemical Engineering | ||
|
آمار تعداد مشاهده مقاله: 524 تعداد دریافت فایل اصل مقاله: 475 |
||
