Physical Characteristics and Topographic Composition of Infectious Waste Combustion Residues in Toxic Hazardous Waste Processing Companies | ||
| Pollution | ||
| دوره 11، شماره 3، پاییز 2025، صفحه 924-937 اصل مقاله (1.57 M) | ||
| نوع مقاله: Original Research Paper | ||
| شناسه دیجیتال (DOI): 10.22059/poll.2025.386840.2694 | ||
| نویسندگان | ||
| Siti Rachmawati* ؛ Hashfi Hawali Abdul Matin؛ Dzakiyy Sholih؛ Devi Mayang | ||
| Department of Environmental Science, Faculty of Mathematics and Natural Science, Universitas Sebelas Maret, Surakarta, Indonesia | ||
| چکیده | ||
| The residue produced and left behind under the burning furnace (incinerator) from the burning of infectious waste is a category of hazardous and toxic waste. The residue from combustion contains heavy metals, which can harm the environment and the health of living creatures. Good management must be implemented to reduce the resulting impacts, one of which is utilization. Appropriate utilization can be done by knowing the characteristics of combustion residues both physically and topographically. The main objective of this research is to analyze the physical characteristics of infectious waste combustion residues and topographic composition. Physical characteristics include water content parameters using SNI 03–1971–1990, mud content parameters using the settling method, gradation parameters using the sieve method, specific gravity parameters using SNI 1970:2008, and water absorption parameters using oven drying. Topographic composition was analyzed using Scanning Electron Microscopy (SEM). The water content obtained in the residue was 9.55%, the mud content was 34.1%, the specific gravity result was 1.82, and the gradation of the ash fell into the zone 2 category, indicating that the fine aggregate tested fell into the medium sand size category, water absorption/absorption shows 10.65%. SEM results show the presence of crystalline particles with sharp edges and flat surfaces, as well as amorphous particles that are more irregular and hollow. Utilization can be done on residues from burning medical waste, one of which is as a substitute for sand in the medium category. Utilization can be made into several products that use medium category sand and are given a additives or pozzolan mixture to prevent leaching. | ||
| کلیدواژهها | ||
| Residues combustion؛ Infectious waste؛ Physical characteristics | ||
| مراجع | ||
|
| ||
|
آمار تعداد مشاهده مقاله: 495 تعداد دریافت فایل اصل مقاله: 400 |
||