Porous Carbon Grain from Coconut Shell Biochar for Permeable Composite Paver | ||
| Journal of Ultrafine Grained and Nanostructured Materials | ||
| دوره 58، شماره 1، شهریور 2025، صفحه 25-32 اصل مقاله (1.01 M) | ||
| نوع مقاله: Research Paper | ||
| شناسه دیجیتال (DOI): 10.22059/jufgnsm.2025.01.03 | ||
| نویسندگان | ||
| Cindy Mutiara Septani* 1؛ Faidliyah Nilna Minah2؛ Mohammad Istnaeny Hudha2؛ Mohammad Erfan3 | ||
| 1Research Center of Polymer Technology, National Research and Innovation Agency of Republic Indonesia | ||
| 2Department of Chemical Engineering, Institut Teknologi Nasional Malang, Indonesia | ||
| 3Department of Civil Engineering, Institut Teknologi Nasional Malang, Indonesia | ||
| چکیده | ||
| Indonesia is one of the world's largest producers of agricultural commodities and waste. The abundance of agricultural waste releases CO2 into the atmosphere and contributes to global warming and climate change. Carbon sequestration is one of the applicable and low-cost technologies to achieve sustainability and net zero emissions. Here, we studied the coconut shell biochar as a composite material for a permeable paving block as an alternative to carbon sequestration. The novelty of this study elaborates on the direct connection between coconut-shell biochar, pyrolysis temperature, and its application as the paving block based on its chemical and physical properties. The pyrolysis temperature of the coconut shell biochar was varied at 400°C and 500°C to obtain biochar with the highest porosity. Biochar pyrolyzed at 500°C possesses the highest porosity with the surface-active area of 32,565 m2/g. Composite pavers were fabricated by mixing the water, fine aggregates, Portland cement, and varied percentages of the ball-milled biochar pyrolyzed at 500°C. The increasing percentage of biochar increases water permeability. Inversely, the increase in biochar percentage reduces the compressive strength. The results show that B20% which consists of 20% biochar is adequate to be utilized as a grade B paving block based on the Indonesian National Standard (SNI) 03-0691-1996. At B20%, the compression strength is 24.7 MPa and the water permeability is 6%. | ||
| کلیدواژهها | ||
| biochar؛ carbon؛ porous material؛ grain؛ paver | ||
| مراجع | ||
|
| ||
|
آمار تعداد مشاهده مقاله: 1,333 تعداد دریافت فایل اصل مقاله: 569 |
||