|تعداد مشاهده مقاله||108,111,329|
|تعداد دریافت فایل اصل مقاله||84,515,744|
قابلیت جذب و پالایش فلزات سمی سنگین از پسماند صنعتی مجتمع فولاد مبارکه از طریق چندین گیاه انباشتگر
|مقاله 12، دوره 40، شماره 1، اردیبهشت 1393، صفحه 153-162 اصل مقاله (421.65 K)|
|نوع مقاله: مقاله پژوهشی|
|شناسه دیجیتال (DOI): 10.22059/jes.2014.50163|
|سید مجید قادریان* 1؛ سمانه نصوحی2|
|1دانشیار گروه زیستشناسی دانشکدۀ علوم دانشگاه اصفهان|
|2کارشناس ارشد فیزیولوژی گیاهی دانشکدۀ علوم دانشگاه اصفهان|
|فلزات سنگین به طور عمده در خاک وجود دارند، اما روند صنعتیشدن و گسترش شهرها سبب پراکندهشدن این فلزات در بیوسفر شده است. آلودگی خاکها به فلزات سنگین نه تنها روی کیفیت محصولات کشاورزی اثر میگذارد، بلکه ممکن است به اتمسفر و آبهای سطحی نیز راه یابد و در نهایت سبب به خطر افتادن سلامت انسان شود. یکی از روشهای مؤثر پاکسازی مکانهای آلوده به فلزات سنگین استفاده از تکنولوژی گیاهپالایی است. در این تحقیق با کشت گیاهان کیسهچوپان، ذرت، آفتابگردان، منداب، کلزا، تاجریزی و چلیپایزرد روی سه نوع پسماند مجتمع فولاد مبارکه قابلیت استقرار، جذب و پالایش فلزات سنگین بررسی شد. از بین گونههای کشتدادهشده روی پسماند صنعتی نوع اول بیشترین مقدار جذب روی، سرب، کروم و نیکل مربوط به کیسهچوپان به مقدار 5/91، 74، 637 و 3/226 میکروگرم در گرم بود، اما این گونه فاقد رشد رویشی مناسب در این نوع پسماند بود. ذرت، آفتابگردان، منداب و کلزا دارای رشد رویشی مناسب بودند و در جذب فلزات سنگین از این نوع پسماند نیز توانایی داشتند. در بین گونههای رشدیافته روی پسماند صنعتی نوع دوم بیشترین مقدار جذب روی و سرب مربوط به گونۀ ذرت به مقدار 1/40 و 98 میکروگرم در گرم و بیشترین مقدار جذب کروم و نیکل مربوط به منداب به مقدار 2/117 و 2/121 میکروگرم در گرم بود. با وجود اینکه ذرت و منداب نسبت به آفتابگردان در جذب بعضی از فلزات موفقیت بیشتری داشتهاند، اما آفتابگردان تنها گونهای بود که توانست روی این پسماند رشد رویشی زیاد داشته باشد و زیستتودۀ بالایی تولید کند. در بین گونههای کشتدادهشده روی پسماند واحد گالوانیزه (نوع سوم) فقط ذرت قابلیت رشد روی این پسماند را داشت و میزان جذب کروم از طریق آن 309 میکروگرم در گرم اندازهگیری شد.|
|پسماند مجتمع فولاد مبارکه؛ گیاهپالایی؛ فلزات سنگین|
|عنوان مقاله [English]|
|Uptake and Removal Capability of Toxic Heavy Metals From the Industrial Discharge of Mobarakeh Steel Complex by Metal Accumulating Plants|
|Seyed Majid Ghaderian1؛ Samaneh Nosouhi2|
|1Associate Professor, Department of Biology, Faculty of Sciences, University of Isfahan, Isfahan, Iran|
|2Master of Science in Plants Physiology, Faculty of Sciences, University of Isfahan, Isfahan, Iran|
Heavy metals are largely found in dispersed form in rock formations. Industrialization and urbanization have increased the anthropogenic contribution of heavy metals in the biosphere. Heavy metal pollution not only affects the production and the quality of crops, but also influences the quality of the atmosphere and water bodies, and threatens the health and life of human beings. Clean-up technologies have been developed for the removal of heavy metals but often these are expensive or have some environmentally deleterious consequences. Phytoremediation emerged in the early 1980s is an important technology for remediation of contaminated sites. One of the most promising phytoremediation technologies is phytoextraction using hyperaccumulators to remove heavy metals from contaminated soils. However, the known hyperaccumulator plants usually accumulate only a specific element and are usually small. Recently, most attention is focused to the plants that produce high biomass and are tolerant to the soils pollutted with heavy metals.
T. caerulescens was found to colonize areas with high Cd, Cu, Pb, and Zn present in soils due to mining. M. chenopodiifolia has good potential for absorbing Pb and Zn. Eruca sativa is tolerante to soil pollution with heavy metals and can accumulate Pb and Cd from contaminated soils. B. napus accumulated cadmium and zinc and translocated these elements into the harvestable parts of the plant. S. nigrum is often found in contaminated areas. It has previously been identified as a Cd hyperaccumulator. H. annuus is known for its high biomass yield. In addition, it is tolerant to soil pollution with heavy metals. Z. mays produce high biomass as well.
In this study, we studied the capability of stability, growth, and uptake of heavy metals by means of T. caerulescen, Z. mays, H. annuus, E. sativa, B. napus, S. nigrum, and M. chenopodiifolia on the industrial discharge of Mobarakeh Steel Complex.
Materials and methods
Mobarakeh Steel Company is located 75 km south west of Isfahan, near the city of Mobarakeh, Isfahan Province, Iran. It is Iran's largest steel maker and one of the largest industrial complexes operating in Iran. Three type effluents (first and second type and galvanized unit) were taken from separated lagoons.
The pH of the soil was determined using a glass electrode after 10 g of soil had been stirred well in 30 ml distilled water in a beaker and allowed to stand for about 30 min. In the first experiment, pots (9 cm diameter) fill up with the first and second types and the galvanized unit effluents separately. The seeds of each plant (T. caerulescen, Z. mays, H. annuus, E. sativa, B. napus, S. nigrum and M. chenopodiifolia) were then sawn on the pots. The pots were irrigated with distilled water every three days for six weeks. The seedlings were irrigated with 100 ml nutrient solution containing 2.46 g/l KH2PO4 ، 4.72 g/l KNO3, and 0.27 g/l Ca(NO3)2 every eight days instead of the distilled water. For the analysis of plant dry matter, the leaf materials were washed well with double-distilled water and dried at 70°C for 48 h. About 0.1 g of dry leaf sample was added to a 25 ml beaker and ashed in a muffle furnace for 6 h at 500°C. The ash was taken up in 10 ml 10% HNO3 and the digest was finally made up to 50 ml in 10% HNO3. The solutions were analyzed for elemental composition by AAS. All soil samples were air-dried and sieved to <2 mm. For the analysis of total elements, sub-samples of 4-5 g were ground to pass through a 80 mesh sieve and then oven-dried at 70°C. A further sub sample of 0.5 g was transferred to a Kjeldahl digestion tube for extraction with 10 ml of a 3:1 HCl/ HNO3 mixture. Tubes were left at room temperature overnight and were then placed in a heating block. Each tube was covered with an air condenser and refluxed gently at 100°C for 1 h. After cooling, the digests were filtered through a moistened filter paper into a 50 ml volumetric flask. The flasks were made to volume with distilled water. Ten milliliters of the digest were added to 15 ml tubes and the analysis for Zn, Pb, Cr, Cd, and Ni was performed by atomic absorption spectrophotometry (AAS, Shimadzu model AA 6200).
The results indicated that in the first type of effluent the amounts of heavy metals were relatively high as follow; Zn (72 mg kg-1), Pb (20 mg kg-1), Cr (28 mg kg-1), Cd (20 mg kg-1), and Ni (118 mg kg-1). In the second type of effluent, these amounts were 68 mg Zn kg-1, 7 mg Pb kg-1, 19 mg Cr kg-1, 21 mg Cd kg-1, and 115 mg Ni kg-1. In galvanized unit effluent, these amounts were high; Zn (353 mg kg-1), Pb (55 mg kg-1), Cr (1768 mg kg-1), Cd (22 mg kg-1) and Ni (114 mg kg-1). The pH of the first and second types and the galvanized unit effluent were 8.4, 8.8, and 9.2, respectively (Table 1).
Table 1. The amounts of heavy metals (mg kg-1) and pH in three types of effluent
Type of effluent
second type galvanized unit
Among species planted on the first type of effluent, H. annuus had more dry weight (910 mg/plant) and M. Chenopodiifolia and T. caerulescens had less dry weight (1 mg/plant). Among the species planted on the second type of effluent, H. annuus had more dry weight (600 mg/plant) and M. Chenopodiifolia and E. sativa had less dry weight (51 mg/plant). Among the species planted on the effluent of the galvanized unit only Z. mays was able to grow. Dry weight of these species was 900 mg/plant as shown in Table 2.
Type of effluent
second type galvanized unit
Table 2. Dry weight of the species planted on three type effluents in mg per plant
The highest accumulation of Zn was taken up by T. caerulescens (91.5 mg/kg). The most accumulation of Pb by T. caerulescens was 74 mg/kg. The most accumulation of Cr by T. caerulescens was 637 mg/kg. The most accumulation of Cd by B. napus was 6.6 mg/kg. The most accumulation of Ni by T. caerulescens was 226.3 mg/kg.
In the second type of effluent, the most accumulation of Zn and Pb by Z. mays was 40.1 mg/kg and 117.2 mg/kg, respectively. The most accumulation of Cr by E. sativa was 117.2 mg/kg. Amount of Cd uptaken by Z. mays, H. annuus, and E. sativa were 12.2 mg/kg, 14.9 mg/kg and 14 mg/kg, respectively. The most Ni accumulation by E. sativa was 121.2 mg/kg.
Z. mays was the only species that could grow on the galvanized unit effluent. It could accumulate Zn, Pb, Cr, Cd, and Ni to 57 mg/kg, 68 mg/kg, 309mg/kg, 32.5 mg/kg, and 55.4 mg/kg, respectively.
In some countries excessive concentrations of toxic heavy metals such as Zn, Pb, Cd, Cr, and Ni in soils in mining areas and around smelters are the sources of serious environmental and health hazards. Among seven species planted on the first type of effluent, T. caerulescens could accumulate Zn, Pb, Cr, and Ni to a large extent and it could almost grow on the industrial discharges. The hyperaccumulator plant T. caerulescens is able to grow on the contaminated soils by heavy metals. These species have received much attention as a potential candidate for phytoextraction of Zn and Cd from the contaminated soils. B. napus could accumulate Cd to a large extent. Brassica family (B. napus, Brassica juncea and R. sativus) has been suggested for phytoremediation of the heavy metals. Four species (Z. mays, H. annuus, E. sativa and B. napus) were able to grow well and uptake heavy metals from all types of effluents. Among seven species planted on the second type of effluent, Z. mays could accumulate Zn and Pb and E. sativa could accumulate Cr and Ni to a large extent. H. annuus was the only species tolerant on the effluent and could produce high biomass yield. Hence, these species have been described or proposed for phytoremediation of the heavy metals. Among seven species planted on the effluent of the galvanized unit, Z. mays was the only one able to well grow and accumulate Cr to a large extent.
Conclusion The acquired results indicated that Z. mays, H. annuus, E. sativa, and B. napus were able to well grow and uptake heavy metals from the first type effluent. Among seven species planted on the second type of effluent, H. annuus was the best species for phytoremediation. For phytoremediation of heavy metals from the galvanized unit effluent, Z. mays was the only suitable species.
|industrial effluent of Mobarakeh Steel Complex, Heavy metals, Phytoremediation|
تعداد مشاهده مقاله: 2,719
تعداد دریافت فایل اصل مقاله: 2,064