Removal of copper and zinc from aqueous solution using nanostructured absorber phragmites australis | ||
| نشریه محیط زیست طبیعی | ||
| Article 2, Volume 71, Issue 3, December 2018, Pages 301-314 PDF (933.25 K) | ||
| Document Type: Research Paper | ||
| DOI: 10.22059/jne.2018.234833.1392 | ||
| Authors | ||
| ali bafkar* 1; hoda kahrizi2; masoma frasati3 | ||
| 1water engineering | ||
| 2graudjuated | ||
| 3razi asisstant profesor | ||
| Abstract | ||
| The aim of this study was to determine the effectiveness of phragmites australis nanostructured for removal of zinc and copper ions from aqueous solutions. Nanostructured phragmites australis was prepared for this purpose and effect of factors such as pH, contact time, initial concentration and adsorbent dosage on the removal of copper and zinc metals in a batch system check and adsorption isotherms and kinetics models were fitted and at the end zinc and copper ions desorbed by the adsorbent was investigated. To determine the absorption characteristics of the test SEM, PSA and FTIR was used. Manufactured by electronic microscopy imaging of nano-adsorbents showed that the percentages of %18.5 was nanoparticle and %81.5 was in the range of nanostructured particles. The results showed that the optimum pH value for both metals was 6, the contact time was 90 min, and initial concentration and adsorbent dosage were 10 ppm and 0.5 g. The Langmuir isotherm model for both zinc and copper ions with maximum R2 (0.98 and 0.99 respectively) and lowest RMSE (0.11 and 0.04 respectively) correlated with data. The kinetic model fitted the model Hoo for both zinc and copper ions with maximum R2 (0.99 and 0.98 respectively) and lowest RMSE (0.04 and 0.07 respectively) most consistent respectively. Desorption results showed that the metals desorption efficiency during 3 cycles for zinc and copper ions (%72 and %75 respectively) occurred in the first cycle. | ||
| Keywords | ||
| "Nanotechnology"; "kinetic"; "isotherm"; "Zinc"; "Copper" | ||
| References | ||
|
Afkhami, A., Saber-Tehrani, M. and Bagheri, H. 2010. Simultaneous removal of heavy-metal ions in wastewater samples usingnano-alumina modified with 2, 4-dinitrophenylhydrazine. Journal of Hazardous Materials. 181: 836–834. Asadi, F. (2002). “Removal of heavy metals from industrial wastewater by rice husk, sawdust and soil”M.S thesis, Esfahan University, Iran (Thesis). Boparai, H.K., Joseph, M., and O’Carroll, D.M. (2011). Kinetics and thermodynamics of Cadmium ion removal by adsorption onto nano zerovalent iron particles Journal of Hazardous Materials. 186 (1), 458-465. Dai Niaki, S.M., Takdastan. A., Zouli M.A. and Mortazavi, M.S. (2013). “Nano-filtration efficiency for the removal of heavy metals from wastewater.” Journal of Water and Wastewater, No 1, 125-131. Ding, D., Lei, Zh, Feng, Ch. and Zhang, Zh. (2014). Selective removal of cesium from aqueous solutions with nickel (II) hexacyanoferrate (III) functionalized agricultural residue–walnut shell. Journal of Hazardous Materials. 270: 187–195. Dos Santos, A., and Masini, J. (2007). “Evaluating the removal of Cd (II), Pb (II) and Cu (II) from a Wastewater sample of a coating industry by adsorption onto vermiculite.” J. of Applied Clay Science, 37(1/2), 167-174. El-Sadaawy M, Abdelwahab O. (2014). Adsorptive removal of nickel from aqueous solutions by activated carbons from doum seed (Hyphaenethebaica) coat.2014; Alexandria Engineering Journal 53:399–408. Escudero, C., Poch, J., and Villaescusa, I. (2013). “Modelling of breakthrough curves of single and binary Mixtures of Cu (II), Cd (II), Ni (II) and Pb (II) sorption onto grape stalks waste.” Chem. Eng. Journal, 217, 129-138. Ezzedine, Z., Batonneau-Gener, I., Pouilloux, Y., Hamad, H., Saad, Z. and Kazpard, V. (2015). Divalent heavy metals adsorption onto different types of EDTA-modified mesoporous materials: Effectiveness and complexation rate. Microporous and Mesoporous Materials. 212: 125-136. Farasati, M., Seyedian, M., Boroomandnasab, S., Jaafarzadeh, N., Moazed, H. and Ghamarnia, H. (2013). Batch and column studies on the evaluation of micrometer and nanometer Phragmites australis for nitrate removal, Desalination and Water Treatment. 51:28-30. Freundlich, H.M.F. (1906). Over the adsorption in solution. Journal of Physics and Chemical. 7:385–470. Gupta, V., Jain, C., Ali, I., Sharma, M., and Saini, V. (2003). “Removal of cadmium and nickel from wastewater using bagasse fly ash a sugar industry waste.” J. of Water Research, 37, 4038-4044. Hegazi, H.A. (2013). Removal of heavy metals from wastewater using agricultural and industrial wastes as adsorbents. HBRC Journal 9, 276–282. Hosseini, S.M., Farokhian Firoozi. A., Babai, A.A. and Heidari zade, F. (2013). “Copper absorption from aqueous solution with modified tea waste with magnetite nanoparticles.” J. of Water and Wastewater, No 4, 112-119. Karami H. (2013). Heavy metal removal from water by magnetite nanorods. Chemical Engineering Journal. 219: 209–216. Kumar, U. (2006). “Agricultural products and by-products as a low cost adsorbent for heavy metal removal from water and wastewater.” Journal of A Review. Scientific Research and Essay, 1(2), 33-37. Langmuir, I. (1918). J. Am. Chem. Soc., 40: 1361. Malakoutian, M., Golpaygani. A.A., and Rajabi zade, A. (2014). “Performance evaluation of nano-filtration process to remove heavy metals lead, cadmium, hexavalent chromium and copper from water containing sulfate.” Journal of Water and Wastewater, No 5, 13-20. Matouq, M., Jildeh, N., Qtaishat, M. and Hindeyeh, M. (2015). The adsorption kinetics and modeling for heavy metals removal from 2 wastewater by Moringa pods. Journal of Environmental Chemical Engineering, on press. Mehrasbi, M., and Farahmand kia. Z. (2008). “Removal of heavy metals from aqueous solution by adsorption on modified banana skins Beverage areas.” Journal of ealth and Environment, 1 (1), 57-66. Ngomsik A.F., Bee A., Siaugue J.M., Talbot D., Cabuil V., Cote .(2009).Co (II) removal by magnetic alginate beads containing Cyanex 272, J. Hazard. Mater. 166:1043–1049. Qian, Q., Mochidzuki, K., Fujii, T., and Sakoda, A. (2009). Removal of copper from aqueous solution using iron-containing adsorbents derived from methane fermentation sludge. J. of Hazardous Materials, 172: 1137-1144. Rahmani, A., Zavvar Mousavi. H., and Fazli, M. (2010). “Effect of nanostructure alumina on adsorption of Heavy metals.” J. of Desalination, 253(1-3), 94-100. Sabry M.S, Fawzy I.E, Khaled M.Gh, Hala M.G. (2013). Heavy metals removal from aqueous solutions and wastewaters by using various byproducts. Journal of Environmental Management 128: 514-521. Shih, H., and Dong, H. (2009). “Rapid removal of heavy metal cations and anions from aqueous solutions by anamino-functionalized magnetic nano-adsorbent.” J. of Hazardous Materials, 163, 174-179. Temkin M.J., Pyzhev V. (1940). Recent modifications of Langmuir isotherms, Acta Physiochin.URSS 12: 217–222. Teng H., Hsieh C.T. (1999). Activation energy for oxygen chemisorption on carbon at low temperature, Ind. Eng. Chem. Res. 38: 292–297. Ulmanu M, Marañón E, Fernández Y, Castrillón L, Anger I, Dumitriu D. (2003). Removal of copper and cadmium ions from diluted aqueous solutions by low cost and waste material adsorbents. Water, Air, and Soil Pollution. 142(1-4):357-73. Xing, X., Gao, Q.Q., Yue, B. and Zhong, Q. (2010). Preparation of agricultural byproduct based anion exchanger and its utilization for nitrate and phosphate removal. Bioresource Technology. 101:8558 8564. Zhao, R., Li, X., Sun, B., Shen, M., Tan, X., Ding, Y., Jiang, Z. and C. Wang. (2015). Preparation of phosphorylated polyacrylonitrile-based nanofiber mat and its application for heavy metal ion removal. Chemical Engineering Journal. 268: 290–299. | ||
|
Statistics Article View: 595 PDF Download: 640 |
||