پیوندهای مفید
اخبار و اعلانات
آمار
| تعداد نشریات | 161 |
| تعداد شمارهها | 6,485 |
| تعداد مقالات | 70,045 |
| تعداد مشاهده مقاله | 123,039,185 |
| تعداد دریافت فایل اصل مقاله | 96,274,547 |
Interfering effects of Iron(II) and Arsenic(III) in the Cerium-based adsorption technology in Bangladesh | ||
| Pollution | ||
| دوره 6، شماره 3، مهر 2020، صفحه 513-519 اصل مقاله (550.17 K) | ||
| نوع مقاله: Original Research Paper | ||
| شناسه دیجیتال (DOI): 10.22059/poll.2020.290154.692 | ||
| نویسندگان | ||
| M. A. Akbor1؛ M. M. Rahman* 2؛ R. Akter2؛ S. Hossain2؛ S. Ahmed3؛ M. A. B. Siddique3؛ A. Nahar3؛ Md. Khabir Uddin4 | ||
| 1Institute of National Analytical Research and Service (INARS), Bangladesh Council of Scientific and Industrial Research (BCSIR), Dhanmondi, Dhaka-1205, Bangladesh Department of Environmental Sciences, Jahangirnagar University, Savar, Dhaka- 1342, Bangladesh | ||
| 2Department of Environmental Sciences, Jahangirnagar University, Savar, Dhaka- 1342, Bangladesh | ||
| 3Institute of National Analytical Research and Service (INARS), Bangladesh Council of Scientific and Industrial Research (BCSIR), Dhanmondi, Dhaka-1205, Bangladesh | ||
| 4Department of Environmental Sciences, Jahangirnagar University, Dhaka, Bangladesh. | ||
| چکیده | ||
| Arsenic (As) contamination in the groundwater of Bangladesh is one of the major public health concerns. It has become a challenge to remove As from groundwater and a great deal of efforts employed in this regards with limited success. Cerium oxide is one of the important medias of arsenic removal techniques. Nine units of cerium-based arsenic technology were tested with seven different well waters in five hydro-geological areas in Bangladesh. Interestingly, the same technology showed variable results in terms of As removal performance from well water. Therefore, this study aimed to investigate the reasons behind the variant performance of the As removal technology. The studied wells were contaminated with a range of 283 to 873 μg/L of arsenic, 0.35 to 10.4 mg/L of iron, 0.29 to 6.83 mg/L of phosphate, 32.5 to 49.5 mg/L of silicate, 0.08 to 0.25 mg/L of sulfate and pH range was 7.11 to 7.65. The cerium-based As removal technology consistently produced As safe water from three wells containing more than 80% As (III) of total arsenic (As) and >3 mg/L of iron and reduced As concentration to below 50 μg/L consistently but failed at other four wells containing less than 75% As (III) of tAs and | ||
| کلیدواژهها | ||
| Adsorption؛ Verification؛ Performance claim؛ Arsenic-removal؛ Groundwater contamination | ||
| مراجع | ||
|
Chakraborti, D., Rahman, M.M., Das, B., Murrill, M., Dey, S., Chandra M. S., Dhar, R.K., Biswas, B.K., Chowdhury, U.K., Roy, S., Sorif, S., Selim, M., Rahman, M. and Quamruzzaman, Q. (2010). Status of groundwater arsenic contamination in Bangladesh: a 14-year study report. Water Res., 44(19); 5789-802. Bose, P. and Sharma, A. (2002). Role of iron in controlling speciation and mobilization of arsenic in subsurface environment. Water Res., 36(19); 4916–4926. Deng, S., Li, Z., Huang, J. and Yu, G. (2010). Preparation, characterization and application of a Ce–Ti oxide adsorbent for enhanced removal of arsenate from water. J Hazard Mater., 179(1-3); 1014–1021. Devi, R.R. Umlong, I.M., Das, B., Borah, K., Thakur, A.J., Raul, P.K., Banerjee, S. and Singh, L. (2014). Removal of iron and arsenic (III) from drinking water using iron oxide-coated sand and limestone. Appl Water Sci., 4;175–182. Genç -Fuhrman, H., Tjell, J.C. and McConchie, D. (2004). Adsorption of arsenic from water using activated neutralized red mud. Environ. Sci. Technol., 38;2428-2434. Hussam, A. and Munir, A.K. (2007). A simple and effective arsenic filter based on composite iron matrix: development and deployment studies for groundwater of Bangladesh. J Environ Sci Health A Tox Hazard Subst Environ Eng.,42(12);1869-78. Jekel, M. (1994). Arsenic removal in water treatment In Arsenic in the Environment (Edited by Nriagu J.), New York: John Wiley & Sons Inc. Jiang, J.-Q. (2001). Removing arsenic from groundwater for the developing world - a review. Water Sci Technol., 44(6); 89–98. Li, R., Li, Q., Gaoa, S. and Shanga, J. K. (2012). Exceptional arsenic adsorption performance of hydrous cerium oxide nanoparticles: Part A. Adsorption capacity and mechanism. Chem Eng J., 185-186; 127-135. Li, Z., Deng, S., Yu, G., Huang, J. and Lim, V. C. (2010). As(V) and As(III) removal from water by a Ce–Ti oxide adsorbent: Behavior and mechanism. Chem Eng J., 161(1-2), 106–113. Munoz, J.A., Gonzalo, A. and Valiente, M. (2002). Arsenic adsorption by Fe (III)-loaded open-celled cellulose sponge. Thermodynamic and selectivity aspects. Environ Sci Technol., 36(15); 3405–3411. Roberts, L.C., Hug, S.J., Ruettimann, T., Billah, M.M., Khan, A. W. and Rahman, M.T. (2004). Arsenic removal with iron (II) and iron (III) in waters with high silicate and phosphate concentrations. Environ Sci Technol., 38(1); 307–315. Rahman, M.M., Islam, M.A., Bodrud-Doza, M., Muhib, M.I., Zahid, A., Shammi, M., Tareq, S.M. and Kurasaki, M. (2018). Spatio-Temporal assessment of groundwater quality and human health risk: a case study in Gopalganj, Bangladesh. Expo Health., 10(3);167-188. Rahman, M. M., Sultana, R., Shammi, M., Bikash, J., Ahmed, T., Maruo, M., Kurasaki, M. and Uddin, M. K. (2016). Assessment of the status of groundwater arsenic at Singair Upazila, Manikganj Bangladesh: Exploring the correlation with other metals and ions. Expo Health., 8(2); 217-225. Rasul, S.B., Munir, A.K.M., Hossain, Z.A., Khan, A.H., Alauddin, M. and Hussam, A. (2002). Electrochemical measurement and speciation of inorganic arsenic in groundwater of Bangladesh. Talanta, 58; 33–43. Sikder, M.T., Rahman, M.M., Jakariya, M., Hosokawa, T., Kurasaki, M. and Saito, T. (2019). Remediation of water pollution with native cyclodextrins and modified cyclodextrins: a comparative overview and perspectives. Chem Eng J., 355;920-941. Yu, L., Ma, Y., Ong, C. N., Xie, J. and Liu, Y. (2015). Rapid adsorption removal of arsenate by hydrous cerium oxide–graphene composite. RSC Adv., 5(80); 64983–64990. Verma, P., Agarwal, A. and Singh, V.K. (2014). Arsenic removal from water through adsorption-A review. Recent Research in Science and Technology., 6(1); 219-226. Zhang, Y., Dou, X., Zhao, B., Yang, M., Takayama, T. and Kato, S. (2010). Removal of arsenic by a granular Fe–Ce oxide adsorbent: Fabrication conditions and performance. Chem Eng J., 162; 164-170. Zhang, Y., Yang, M. and Huang, X. (2003). Arsenic(V) removal with a Ce(IV)-doped iron oxide adsorbent. Chemosphere., 51; 945 —952. | ||
|
آمار تعداد مشاهده مقاله: 914 تعداد دریافت فایل اصل مقاله: 535 |
||