پیوندهای مفید
اخبار و اعلانات
آمار
| تعداد نشریات | 161 |
| تعداد شمارهها | 6,478 |
| تعداد مقالات | 70,016 |
| تعداد مشاهده مقاله | 122,935,533 |
| تعداد دریافت فایل اصل مقاله | 96,149,567 |
Application of Artificial Neural Network for Stability Analysis of Undercut Slopes | ||
| International Journal of Mining and Geo-Engineering | ||
| مقاله 1، دوره 55، شماره 1، شهریور 2021، صفحه 1-6 اصل مقاله (1.05 M) | ||
| نوع مقاله: Research Paper | ||
| شناسه دیجیتال (DOI): 10.22059/ijmge.2020.292606.594832 | ||
| نویسندگان | ||
| Hassan Sarfaraz1؛ Mohammad Hossein Khosravi* 1؛ Thirapong Pipatpongsa2؛ Hassan Bakhshandeh Amnieh1 | ||
| 1School of Mining Engineering, College of Engineering, University of Tehran,Tehran, Iran | ||
| 2Department of Urban Management, Kyoto University, Japan | ||
| چکیده | ||
| One of the significant tasks in undercut slopes is determining the maximum stable undercut span. According to the arching effect theory, undercut excavations cause the weight of the slope to be transmitted to the adjacent stable regions of the slope, which will increase the stability of the slope. In this research, determining the maximum width of undercut slopes was examined through numerical modeling in the FLAC3D software. For this purpose, a series of undercut slope numerical models, with various slope angles, horizontal acceleration coefficients, and counterweight balance widths was conducted, and the results were validated using the corresponding experimental test results. The effect of each parameter on the maximum stable undercut span was investigated with an artificial neural network, where a multi-layer perceptron (MLP) model was performed. The results showed good accuracy of the proposed MLP model in the prediction of the maximum stable undercut span. In addition, a sensitivity analysis demonstrated that the dip angle and horizontal acceleration coefficient were the most and least effective input variables on the maximum stable undercut span, respectively. | ||
| کلیدواژهها | ||
| Undercut Slope؛ Numerical Modelling؛ Artificial Neural Network؛ Multi-layer Perceptron Model | ||
| مراجع | ||
|
[1] R. L. Handy, “The Arch in Soil Arching,” J. Geotech. Eng., vol. 111, no. 3, pp. 302–318, Mar. 1985.
[2] H. A. Janssen, “Versuche uber getreidedruck in Silozellen,” Zeitschrift des Vereins Dtsch. Ingenieure, no. 35, pp. 1045–1049, 1895.
[3] K. Terzaghi, “Theoretical soil mechanics. John Wiley & Sons, New York.,” Theor. soil Mech. John Wiley Sons, New York. , 1943.
[4] P. J. Bosscher and D. H. Gray, “Soil Arching in Sandy Slopes,” J. Geotech. Eng., vol. 112, no. 6, pp. 626–645, 1986.
[5] M. Khosravi, “Arching effect in geomaterials with applications to retaining walls and undercut slopes,” PhD. Dissertation, Tokyo Institute of Technology, 2012.
[6] T. Pipatpongsa, M. H. Khosravi, P. Doncommul, and N. Mavong, “Excavation problems in Mae Moh lignite open-pit mine of Thailand,” in Proceedings of Geo-Kanto2009, 2009, vol. 12, pp. 459–464.
[7] M. H. Khosravi, T. Pipatpongsa, C. Leelasukseree, and P. Wattanachai, “Failure mechanisms in arched excavation of sloped earth using model test,” Proc. Geo-Kanto2009, vol. 12, pp. 241–246, 2009.
[8] M. H. Khosravi, Y. Ishii, J. Takemura, and T. Pipatpongsa, “Centrifuge model test on compacted sand slopes undercut by inflight excavator,” Proc. Geo-Kanto2010, pp. 4–5, 2010.
[9] M. Khosravi, T. Pipatpongsa, A. Takahashi, and J. Takemura, “Arch action over an excavated pit on a stable scarp investigated by physical model tests,” Soils Found., vol. 51, no. 4, pp. 723–735, 2011.
[10] M. Khosravi, L. Tang, T. Pipatpongsa, J. Takemura, and P. Doncommul, “Performance of counterweight balance on stability of undercut slope evaluated by physical modeling,” Int. J. Geotech. Eng., vol. 6, no. 2, pp. 193–205, Apr. 2012.
[11] M. Khosravi, H. Sarfaraz, M. Esmailvand, and T. Pipatpongsa, “A Numerical Analysis on the Performance of Counterweight Balance on the Stability of Undercut Slopes,” Int. J. Min. Geo-Engineering, vol. 51, no. 1, pp. 63–69, 2017.
[12] M. H. Khosravi, J. Takemura, T. Pipatpongsa, and M. Amini, “Inflight excavation of slopes with potential failure planes,” J. Geotech. Geoenvironmental Eng., vol. 142, no. 5, p. 6016001, 2016.
[13] R. Ouch, B. Ukritchon, and T. Pipatpongsa, “Stability of soil block on low interface friction plane with and without side supports,” Eng. J., vol. 20, no. 2, pp. 123–145, 2016.
[14] R. Ouch, B. Ukritchon, T. Pipatpongsa, and M. H. Khosravi, “Experimental investigations of shear pin arrangement on soil slope resting on low interface friction plane,” Maejo Int. J. Sci. Technol., vol. 10, no. 3, pp. 313–329, 2016.
[15] R. Ouch, B. Ukritchon, T. Pipatpongsa, and M. H. Khosravi, “Finite element analyses of the stability of a soil block reinforced by shear pins,” Geomech. Eng., vol. 12, no. 6, pp. 1021–1046, 2017.
[16] B. Ukritchon, R. Ouch, T. Pipatpongsa, and M. H. Khosravi, “Investigation of stability and failure mechanism of undercut slopes by three-dimensional finite element analysis,” KSCE J. Civ. Eng., vol. 22, no. 5, pp. 1730–1741, 2018.
[17] B. Ukritchon, R. Ouch, T. Pipatpongsa, and M. H. Khosravi, “Experimental studies of floor slip tests on soil blocks reinforced by brittle shear pins,” Int. J. Geotech. Eng. , vol. 13, no. 1, pp. 1–8, 2019.
[18] B. Ukritchon, R. Ouch, T. Pipatpongsa, and M. H. Khosravi, “Physical and numerical studies of stability of soil blocks reinforced by brittle shear pins,” Acta Geotech., vol. 14, no. 6, pp. 2103–2122, 2019.
[19] S. L. Kramer, Geotechnical earthquake engineering. In prentice-- Hall international series in civil engineering and engineering mechanics. 1996.
[20] D. E. Rumelhart, G. E. Hinton, and R. J. Williams, “Learning representations by back-propagating errors,” Nature, vol. 323, no. 6088, pp. 533–536, 1986.
[21] L. V Fausett and others, Fundamentals of neural networks: architectures, algorithms, and applications , vol. 3. Prentice-Hall Englewood Cliffs, 1994.
[22] R. Rojas, Neural networks: a systematic introduction. Springer Science & Business Media, 2013.
[23] A. Majdi and M. Rezaei, “Application of Artificial Neural Networks for Predicting the Height of Destressed Zone Above the Mined Panel in Longwall Coal Mining,” 47th US Rock Mech. Symp., 2013.
[24] F. Rosenblatt, “The perceptron: A probabilistic model for information storage and organization in the brain,” Psychol. Rev., vol. 65, no. 6, pp. 386–408, 1958.
[25] I. Flood and N. Kartam, “Neural Networks in Civil Engineering. I: Principles and Understanding,” J. Comput. Civ. Eng., vol. 8, no. 2, pp. 131–148, Apr. 1994.
[26] M. H. Den Hartog, R. Babuška, H. J. R. Deketh, M. Alvarez Grima, P. N. W. Verhoef, and H. B. Verbruggen, “Knowledge-based fuzzy model for performance prediction of a rock-cutting trencher,” Int. J. Approx. Reason., vol. 16, no. 1, pp. 43–66, 1997.
[27] T. J. Ross, Fuzzy Logic With Engineering. Second Edition. 2004.
[28] A. Rastbood, Y. Gholipour, and A. Majdi, “Stress Analysis of Segmental Tunnel Lining Using Artificial Neural Network,” Period. Polytech. Civ. Eng., vol. 61, no. 4, pp. 664–676, 2017.
[29] C. Leelasukseree, T. Pipatpongsa, M. H. Khosravi, N. Mavong, and others, “Stresses and a failure mode from physical and numerical models of undercut slope lying on inclined bedding plane,” in ISRM Regional Symposium-7th Asian Rock Mechanics Symposium, 2012.
[30] I. G. Inc, "FLAC3D Fast Lagrangian Analysis of Continua in 3 Dimension. 2015.
[31] B. Etzkorn, “Data normalization and standardization,” BE BLOG [Online]. Available http//www. benetzkorn. com/2011/11/datanormalization-and-standardization, 2011
| ||
|
آمار تعداد مشاهده مقاله: 835 تعداد دریافت فایل اصل مقاله: 845 |
||