تعداد نشریات | 161 |
تعداد شمارهها | 6,489 |
تعداد مقالات | 70,096 |
تعداد مشاهده مقاله | 123,160,183 |
تعداد دریافت فایل اصل مقاله | 96,391,578 |
Performance of Impulse Response Testing on Prismatic Members with Intermediate Joints | ||
Civil Engineering Infrastructures Journal | ||
دوره 54، شماره 1، شهریور 2021، صفحه 195-204 اصل مقاله (867.31 K) | ||
نوع مقاله: Technical Notes | ||
شناسه دیجیتال (DOI): 10.22059/ceij.2020.292705.1629 | ||
نویسندگان | ||
Saman Rashidyan* 1؛ Arup Maji2؛ Tang-tat Ng2 | ||
1Senior Lecturer, Department of Engineering Technology, University of North Texas, 3940 N Elm St, Denton, TX 76207 USA | ||
2Civil Engineering Department, University of New Mexico, Albuquerque, NM, USA | ||
چکیده | ||
Nondestructive Testing (NDT) methods have extensively been used to assess the conditions of civil infrastructure in the recent decades. Among various NDT techniques, Impulse Response (IR) has a vast application due to its simplicity and low cost. However, factors such as reflections from changes in impedance along the investigated members can adversely influence the success of the method. Numerous numerical and experimental studies have already been performed to evaluate the effect of change in mechanical impedances such as bulging, necking and similar anomalies. In this study, the effect of the presence of joints connecting the investigated members to other members, as another source of impedance change, is demonstrated. A three-story steel-concrete composite column of a building was selected for testing and IR tests were conducted. The obtained mobility graphs were clear, and the height of the column was easily measured with an acceptable error. The results of this study show that although the joints located between the top and bottom of the tested member are sources of change in mechanical impedance, they do not result in concealing the resonant frequencies from the wave reflected from the bottom of the member. Thus, IR method seems to be applicable in determining the length of prismatic members with intermediate joints such as piles of unknown bridge foundations with bracing and columns of buried buildings. | ||
کلیدواژهها | ||
Bridge؛ Building؛ Foundation؛ Impulse Response؛ Pile | ||
مراجع | ||
American Concrete Institution (ACI). (2013). "Report on nondestructive test methods for evaluation of concrete in structures”, ACI Committee 228, Report, 83 p., American Concrete Institute, Michigan, IL.
American Society for Testing Materials (ASTM). (2013). "Standard test method for low strain impact integrity testing of deep foundations", ASTM International, West Conshohocken, PA.
Baxter, S.C., Islam, M.O., and Gassman, S.L. (2004). "Impulse response evaluation of drilled shafts with pile caps: modeling and experiment", Canadian Journal of Civil Engineering, 31, 169-177.
Briaud, J.L., Ballouz, M., and Nasr, G. (2002). "Defect and length predictions by NDT methods for nine bored piles", Deep Foundations International Perspective on Theory, Design, Construction, and Performance, pp. 173-192, Orlando, FL, United States.
Coe, J.T., Nyquist, J.E., Kermani, B. and Sybrandy, L. (2013). "Application of non-destructive testing to evaluate unknown foundations for Pennsylvania bridges", Pennsylvania. Department of Transportation, Bureau of Planning and Research, Harrisburg, PA.
Finno, R.J. and Gassman, S.L. (1998). "Impulse response evaluation of drilled shafts", Journal of Geotechnical and Geoenvironmental Engineering, 124, 965-975.
Finno, R.J., Gassman, S.L. and Osborn, P.W. (1997). "Non-destructive evaluation of a deep foundation test section at the Northwestern University national geotechnical experimentation site", A Report submitted to the Federal Highway Administration Office, Northwestern University, Evanston, Illinois.
Hertlein, B. and Davis, A. (2007). Nondestructive testing of deep foundations, Wiley, New York.
Kurup, A.R. and Kumar, K.S. (2017). "Novel fibrous concrete mixture made from recycled PVC fibers from electronic waste", Journal of Hazardous, Toxic, and Radioactive Waste, 21(2), 1-7.
Liao, S.T., Huang, C.K. and Wang, C.Y. (2008). "Sonic echo and impulse response tests for length evaluation of soil nails in various bonding mediums", Canadian Geotechnical Journal, 45, 1025-1035.
Murasaka, M. and Suzuki, M. (2015). "Study on propagation behavior of elastic wave in concrete by using the concrete specimen", International Symposium Non-Destructive Testing in Civil Engineering (NDT-CE), Berlin, Germany.
Ni, S.H., Huang, Y.H., Lo, K.F. and Charng, J.J. (2011). "Estimating the flaw size in drilled shafts using an impulse response method", KSCE Journal of Civil Engineering, 15, 1197.
Rashidyan, S., Ng, T.T., and Maji, A. (2016). "Bridge foundation depth estimation using sonic echo test", Experimental and Applied Mechanics, C. Sciammarella, J. Considine, and P. Gloeckner (Eds.), Springer International Publishing, 4, 99-106.
Rashidyan, S., Ng, T.T., and Maji, A. (2017). "Estimating the depth of concrete pier wall bridge foundations using nondestructive sonic echo", Journal of Nondestructive Evaluation, 36, 56.
Rashidyan, S., Maji, A., and Ng, T.T. (2019a). "Performance of nondestructive sonic echo testing method on partially dismantled unknown wood bridge foundations, A case study", Civil Engineering Infrastructures Journal, 52(2), 205-224.
Rashidyan, S., Ng, T.T, and Maji, A. (2019b). "Practical aspects of nondestructive induction field testing in determining the depth of steel and reinforced concrete foundations", Journal of Nondestructive Evaluation, 38, 19.
Sajid, S. and Chouinard, L. (2019). "Impulse response test for condition assessment of concrete: A review", Construction and Building Materials, 211, 317-328.
Wu, S., Lai, J., Cheng, C.F. and Yang, B.H. (2015). "Integrity testing of model piles with pile cap", Proceedings of NDT-CE, 920-927, Berlin, Germany. | ||
آمار تعداد مشاهده مقاله: 492 تعداد دریافت فایل اصل مقاله: 307 |