[1] Esor, E., Dresda, S. and Monico, C. (2004). “Use of material balance to enhance 3D reservoir simulation: A case study.” SPE 80907, SPE Ann. Tech. Conf. Exhibition., Houston, Texas.

[2] Ahmed, T.H., Centilmen, A. and Roux, B.P. (2006). “A generalized material balance equation for coalbed methane reservoirs.” SPE 102638, SPE Ann. Tech. Conf. Exhibition., San Antonio, Texas.

[3] Pletcher, J.L. (2000). “Improvements to reservoir material balance methods.” SPE 62882, SPE Ann. Tech. Conf. Exhibition., Dallas, Texas.

[4] Walsh, M.P. (1995). “A generalized approach to reservoir material balance calculations.” J. Can. Pet. Technol., Vol. 34, No. 1, pp. 55-63.

[5] Ahmed, A. and McKinney, P. (2005). Advanced reservoir engineering. Chapter 4, Gulf Prof. Pub. Co., Houston, Texas.

[6] Firoozabadi, A. (2001). “Mechanism of solution gas drive in heavy oil reservoirs.” J. Can. Pet. Technol, Vol. 40, No. 3, pp. 15-20.

[7] Niz-Velasquez, E., Moore, R.G., Mehta, S.A. and Ursenbach, M.G. (2006). “Reservoir simulation assessment of the oil recovery mechanisms in high-pressure air injection (HPAI).” Canadian Int. Petr. Conf., Calgary, Alberta.

[8] Myers, T.J., and Radke, C.J. (2000). “Transient foam displacement in the presence of residual oil: experiment and simulation using a population-balance model.” Ind. Eng. Chem. Res., Vol. 39, No. 8, pp. 2725-2741.

[9] Wu, H., Zhou, F. and Wu, Y. (2001). “Intelligent identification system of flow regime of oil–gas–water multiphase flow.” Int. J. Multi. Flow., Vol. 27, No. 3, pp. 459-475.

[10] Schilthuis, R. (1936). “Active oil and reservoir energy.” Trans. AIME., Vol. 118, pp. 33-38.

[11] Cole, F.W. (1969). Reservoir Engineering Manual, Gulf Publ. Co., Houston, Texas, pp. 285.

[12] Dake, L.P. (2001). The Practice of Reservoir Engineering. Chapter 3, Elsevier, Amsterdam, Netherlands.

[13] Eclipse 100 Reference Manual, (2009.1). Schlumberger.