1.

Effects of heat treatment on the microstructural stability, mechanical properties and degradability of as-cast Mg–1Y and Mg–1Ca alloys: A comparative study

صفحه 1-8
Meysam Mohammadi–Zerankeshi؛ Reza Ghanbari؛ Reza Alizadeh

2.

Non-uniform simple shear extrusion (NUSSE) technique as a novel sever plastic deformation technique

صفحه 9-18
Ali Izi؛ Mohammad Honarpisheh؛ Farshid Ahmadi

3.

Corrosion behavior of cold rolled and continuously heated SUS 304L stainless steel

صفحه 19-27
Mohammad Javad Sohrabi؛ Changiz Dehghanian؛ Hamed Mirzadeh

4.

Morphology and mechanical properties of 3D printed PCL-PLA-ZnO nanocomposite scaffolds for bone regeneration

صفحه 28-34
Mozhdeh Peiravi؛ Zahra Sherafat

5.

Effect of some processing parameters on microstructure and hardness profiles of Al-Al2Cu functionally graded composites prepared in-situ via interaction between molten Al and solid Cu

صفحه 35-47
Fatemeh Mashayekhi؛ Farshad Akhlaghi

6.

Effect of thickness on photoconversion efficiency of Al2TiO5/TiO2/Al2O3 nanocomposite films as photoanode in water splitting

صفحه 48-60
Shima Kashani؛ Hamid Reza Madaah Hosseini

7.

The potential antibacterial application of Mg-doped zinc oxide nanoparticles synthesized through sol-gel method

صفحه 61-67
Roghaieh Shahriiari؛ Mohammad Ghorbanpour

8.

Low-cost Li2S-based cathode for lithium sulfur battery

صفحه 68-74
Hamid Mollania؛ Majid Oloomi-Buygi

9.

Grain refinement tracing of dynamic and metadynamic recrystallization for a Penetrator Steel

صفحه 75-81
Taher El-Bitar؛ Maha ElMeligy؛ Wojciech Borek؛ Saad Ebied

10.

Thermoelectric performance of bilayer and multilayer SnSe/Bi2Te3 thin films prepared by physical vapor deposition

صفحه 82-91
Tamilarasi R؛ Magesh R؛ Joelin C؛ Suryakanth J؛ RAJESH S

11.

Conductive nanofibrous scaffold based on polyvinyl alcohol/cellulose nanocrystals/ reduced graphene oxide composite reinforced with curcumin for wound healing

صفحه 92-103
Bakhshali Massoumi؛ Raana Sarvari؛ Elaheh Fakhri؛ Khadijeh Emami Rad

12.

An investigation on microstructures and residual stresses of pure copper sheets fabricated by constrained studded pressing

صفحه 104-111
Mohamad Mahdi kaykha؛ SaraSadat Hosseini Faregh


سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب